MICRO SEVEN, INC.â, MULTI-LINE TELEPHONE CABLE SIMULATOR, Model PC300-CSXX, SIMULATES MULTI-LINE TWISTED TELEPHONE CABLES

MICRO SEVEN, INC.â, MULTI-LINE TELEPHONE CABLE SIMULATOR, Model PC300-CSXX, is housed in a PC300-32AD chassis shown in the above picture.

INTRODUCTION

Micro Seven, inc.â, Multi-line Telephone Cable Simulator, model PC300-CSXX provides simulation of maximum sixteen twisted copper pairs of cable for both analog telephone and DSL modems. The “XX” after the word “PC300-CS” indicates a number of simulated cable pairs, i.e. PC300-CS08 provides eight cable pairs. The PC300-CSXX simulates cable resistance, capacitance, inductance and conductance for maximum 15 kilometers (CS10-1) of telephone lines depending on its configuration for each 1km increment. The Windows-type control software as a standard accessory provides programming of cable distance for each cable pair between 1 and 15 km. The PC300-CSXX front panel contains two RJ11 connectors for each cable pairs and power indicator. Programming of cable distance for each cable pair is accomplished by Windows-compatible control software and RS232C interface. Programmed parameters are stored in non-volatile memory inside PC300-CSXX, and on the power-up PC300 restores all programmed parameters without PC connected. Each cable pair is isolated from earth ground.

SPECIFICATIONS:

Telephone cable simulation:
distance: 1km to 15 km in 1km increment
simulation of #26AWG (0.5 mm diameter copper wire) telephone cable, twisted pair

High voltage isolation between signal in input and output telephone jack: 1.5kV

Serial interface and programming software:

Windows compatible control software is provided as standard accessory, or using Hyperterminal for command entries

RS232 interface in 1200 baud, 1 stop bit, and no parity

Serial interface that is connected to RS232c interface of PC compatible computer provides the following:
1. Changes cable distance between 1 and 15 km in 1 km increment.

Front panel controls:

Telephone jacks: input to PBX or central office, and output to CPE or telephone-set
Power indicator, green LED

Rear panel controls:

1. RS232 connector

2. power switch

3. fan

4. fuse holder

5. power connector

POWER: 100-250VAC, 50/60HZ, 100 Watts maximum

FUSE: 1 A, 3AG, SLO-BLO

Dimensions: 19-inch Wide x 6.0 in High x 15 in Long (rack-mount and table top )

Weight: 17 lbs.

Environmental: Operating Temperature: 0 to 30 degree C
Storage Temperature: -15 to 55 degree C
Humidity: 85% RH at 45 degree C, or 90% RH at 30 degree C

Warranty/Service: 6 months limited warranty. Service performed at the factory, usually within ten(10) working days.

MICRO SEVEN, INC.â 1095-K N.E. 25^th Ave. Hillsboro, OR 97124 U.S.A.
sales@microseveninc.com
www.microseveninc.com
phone: 503-593-6982, fax: 503-693-9742

Note: our office hour is 8 am to 5 pm Pacific Standard Time.