Micro Seven Inc. model QP20, Panic Switch/Alarm contains a panic switch and sound detection which generate loud siren sound.

Copyrights Micro Seven, Inc., 2024

Features:

-loud siren generation by Panic Switch or excessive sound triggering

-integral microphone and audio speaker

-a burglar alarm by excessive sound triggering when it is armed

-AC/DC power adapter

-wall-mountable

-big RED panic button on the front

-low-cost with no telephone line nor internet required

-It does not require any contracts with alarm companies.

-Stand-alone unit

Typical usages:

-provides medical or emergency alert to your other family member when the panic button is pushed.

-arm QP20 before you vacate your house so that any intruder will hear loud siren sound.

-night time burglar alarm at a patio door or front door when it is armed.

Micro Seven model QP20 is shown in the above picture with a panic switch, audio speaker, power connection.

Power indicator (green LED) and Arm indicator (red LED) and Arm/Disarm/Reset Siren are also shown in the above picture.

Introduction:

When the panic switch on QP20 is pushed, siren sound is generated over the integral speaker on QP20. Since siren sound is so strong that for your other family member can hear the sound to get you for medical emergency or purposes.

QP20 contains excessive sound triggering for generating the same siren sound as the panic switch, but the siren sound generation by excessive sound requires QP20 to be armed by pushing the arm/disarm switch. In order for the panic switch to work, QP20 is not required to be armed.

Specifications:

Operating temperature: 0 to +40°C

Operating environment: Indoor use only

Audio speaker: located on its top section

Microphone: located on its side section

Power indicator: green color and it is located on its side section.

Panic Switch: it is located on its top section

Arming/Disarming Switch: it is located on its side section. When it is pushed after non-armed state, it becomes pre-alarm state for ten seconds with arm LED flashes. After ending pre-alarm state, the arm LED stays on continuously and any excessive sound is detected with siren on.

Armed indicator: red color LED and it is located on its side section.

Power switch: located on its side section

Instrument Power input: by provided an 117VAC/12V DC power adapter

Wall-mountable: with four screw holes provided.

Siren period: four minutes. The siren generation may be stopped when pushing the Arming/Disarming Switch continuously for one second until it is stopped. Once the siren is stopped, you may stop pushing the Arming/Disarming Switch.

Warranty: six months

Portland, OR

Made in U.S.A.

Micro Seven, Inc.

Home Page: www.microseveninc.com

Email: sales@microseveninc.com